WellGate-2504 4-lines FXS SIP IP Gateway

Dual IP Stack : IPv6 and IPv4 Simultaneously Support up to 4 SIP proxy Servers Support different SIP Trunk to each FXS line Auto HTTP Provision feature Flexible Routes Plan and Dial Plan Redundant Firmware Image

Introduction

WellGate 2504 is an 4-line FXS gateway with SIP protocol IP device which allows to connect 4 sets of analog telephone sets to make or receive VoIP call over Internet or VPN network through Internet Telephony service provider. This device is suitable for office user through ITSP service provider to install at office or branch office to call between different offices. It also can install at trunk line in front of digital PBX to migrate digital PBX to IP Telephony call.

To select up to 4 SIP service Accounts

WellGate 2504 is appropriate to use four VoIP Service Providers, IP Centrex service and IP-PBX within offices and remote branch offices. One of four SIP Servers ( or ITSP Service provider or alternative IP-PBX ) can be configured freely at each line ( FXS port ) to make or receive IP Call. It provides 4 service platforms to select lowest rate according to your dial number or country.

IPv6 VoIP Gateway is ready to Market

IPv6 address was developed for years, however, it was not practical to our life up to date. More and more electronic devices are able to link to IP Network, this makes existing IPv4 address supply in shortage to global market. Meanwhile, the emerging countries are not able to increase IPv4 address supply due to strong market demand on broadband services. WellGate 2504 is an SIP based FXS gateway which built-in both IPv6 and IPv4 IP address. No matter when you are ready to deploy IPv6 network now, or reserve the future expansion to IPv6 from existing IPv4 address, WellGate2504 is ready to grow up with you. Both IPv6 and IPv4 address are working simultaneously at Voice IP Call. Its flexibility of both IPv6 and IPv4 accept and interwork both addresses on today and tomorrow whenever you need.

Flexible Dial plan and Route Plan Features

WellGate 2504 provides flexible Dial Plan from FXS to IP Trunk (SIP Softswitch). Dial Plan is to configure in what condition the digits can be sent out to IP network. The dial inter digit time before dialing is configurable to meet busy users or home user. Dial Rule is able to detect the prefix code and maximum digits reached and then dial automatically. The Digit Manipulation (DM) allows you to configure matched prefix code, digits length, start and stop digit position to be replaced digits as well. Route Plan is to configure the incoming and outgoing call routes which you desired this call to go out or allow to income. For instance, IP incoming call may Ring to FXS port with Priority, Cyclic or Simultaneously ring . You can also configure IP incoming call by Matched prefix digits, Matched incoming FXS line number and Matched digit length. For FXS outgoing call routes, the hunting type supports Priority, Cyclic or Simultaneously ring and select which SIP trunk ( SIP Proxy Server ) to go. FXS outgoing call routes also support by Matched prefix digits, Matched incoming FXS line number and Matched digit length. Both direction supports No Answer time out and Backup Routes.

Suit to IP Telephony Service Provider

WellGate 2504 is a SIP IP device to connect with existing analog telephone set to make IP call. Its compact design and easy installation allow office user or single user to make or receive call just like an legend telephone call but less cost. It is compatible with broadband internet service device such as ADSL/Cable Modem and WiMax/3G Modem. It helps ISP provider to provide Telephony service to existing customer without additional cable.

Specification

Interface: Ethernet port (RJ-45, 10/100 base-T) 1-WAN port, connect to IP Network 1-LAN port connect to PC with NAT Support Bridge, NAT and Gateway mode Telephony port (RJ-11 x 4 pcs) DC +12V power input Jack Reset key to return Factory setting LED Indicator for System, SIP and FXS status IP Network connection IPv4 (RFC 791) and IPv6 Simultaneously IPv6 Auto Configuration (RFC 4862) IPv6 Only, IPv4 Only or dual stack MAC Address (IEEE 802.3) MAC Clone Setting Vendor Class ID IP/ICMP/ARP/RARP/SNTP Static IP DHCP Client (RFC 2131), WAN port DHCP Server, LAN port NAT Server (RFC 1631) PPPoE Client DDNS ( DynDNS ) DNS Client Firewall URL Filter IP Filter MAC Address Filter Application program Filter Port Filter Port Forwarding Bandwidth Control (Download and Upload), Maximum Bandwidth priority setting UPnP Server at LAN port Behind NAT, use DMZ for NAT traversal SNTP with time zone and Daylight Saving TCP/UDP (RFC 793/768) RTP/RTCP (RFC 1889/1890) IPV4 ICMP (RFC 792), TFTP Client VLAN Support 802.1Q, 802.1P VLAN ID Range : 2 to 4094 VLAN Priority : 0 to 7 QoS : DiffServ (RFC 2475), TOS (RFC791, 1394) SIP Protocol : RFC3261 compliance Support up-to 4 SIP Server Register Accounts SIP UDP Protocol Support SIP compact Form Support SIP HOLD Type SIP Session Timer (RFC 4028) MD5 Digest Authentication (RFC2069/RFC2617) Reliability of provisional response PRACK (RFC3262) Early/Delay Media support Offer/Answer (RFC3265) Message Waiting Indication (RFC3842) Event Notification (RFC3265) REFER (RFC3515) Support Outbound Proxy Support Primary and Backup SIP Server Support STUN NAT Traversal Support “rport” parameter (RFC 3581) Audio Codec : G.711 A-law/μ-law, G.729A, G.723.1 (6.3K, 5.3K) Select voice codec priority : Local or Remote Silence Suppression VAD/CNG LEC : Line Echo Canceller Max Echo Tail Length (G.168): 32, 64 and 128ms Packet Loss Compensation Automatic Gain Control In-band/out of band DTMF (RFC4733, RFC2833 / SIP INFO) Adaptive/Configurable Jitter Buffer G.168 Acoustic Echo Cancellation Phone Book ( 50 records ) for peer to peer calls Dialing Plan with drop, replace, Insert dialing digits Select First digit and Inter digit timeout duration (Sec) Selectable Call Progress Tone Support Specified Line Calling Call Features : Caller ID display DTMF (before/after 1st ring) and FSK (before 1st ring ), ETSI and Bellcore DTMF Caller ID start and stop BIT configurable Polarity Reversal before Caller ID or not Tone Generation: Ring, Ring Back, Dial, Busy, call waiting, ROH, Warning, Holding, Stutter dial tone and disconnect tone Configure Tone Frequency, Cadence, Level and Cycle Global Country Based Tone Specification NAT Traversal support STUN, UPnP and Behind NAT Out-Band DTMF : RFC2833 and SIP Info Flash Time transmit via SIP Info (Enable or Disable) Message Waiting Indication (Stutter Tone Notice) Speed Dialing Call Waiting/Switching between Calls Call Forward (Busy, Unconditional, No Answer) Block Anonymous Call Call Hold Call Transfer Retrieve transfer call from 3rd party by dial Code (default: *#) Flexible Dial Plan Dial Rule : Prefix and Maximum digits, digit position to replace Digit Manipulation (Drop and Replace Rule) Extension Hunting Hot Line Support SIP Trunk up 4 SIP Servers Outgoing SIP Caller ID Selection Accept desired SIP Proxy incoming calls Only Flexible Routing Plan Prefix Match and Length Priority Ring Cyclic Ring Simultaneous Ring Programmable Hunting Cycle Backup Routing with Digit Manipulation Default Routing T.38 FAX Support Peer to Peer Dialing Flash Time Detection: range from 80 to 800 ms ON-HOOK Voltage -48Vdc Configure Ring Cadence, Frequency and Voltage Support Polarity reversal for Billing Service Up to 1 Kilo-meter distance to analog telephone set Generate Current Drop Time (Open Loop Disconnect time) MANAGEMENT : Administrative Telnet CLI and HTTP, HTTPS http provision through MAC address Multilingual Web User Interface 3 Levels of User Access Right with Password protection (Administrator, Supervisor and User) HTTP/HTTPS Service Access limitation from WAN port Provides System Status Logs Status display: Network, Line, SIP Trunk status Diagnostics (debug through Syslog Event Notice) Debug in real time by Telnet Auto Provision via HTTP Server Support SNMP V2/Trap Configuration Backup/Restore Dual Firmware Image Backup Reset to factory Default ** Support Welltech proprietary encryption protocol at SIP Signal and Voice codec during transmitting to IP network in order to Anti-ISP block of VoIP call. This feature only be available with Welltech SIP server or SIPPBX6200 IP-PBX Environmental : Dimension: 17.5(W) × 3.2(H) × 12.6(D) CM Weight: 0.9kg (One unit with packing) Operating Temp. & Humidity Temp.: 0°C~45°C (32°F~113°F) Humidity: 10%~90% relative humidity, non-condensing Power Adaptor: INPUT: AC100V~240V, 50/60Hz OUTPUT: DC 12V, 1.5A Power Consumption: 15 Watts. Approvals: CE, FCC (Part 15, Class B), LVD and RoHS Country of origin: Made in Taiwan Packing Accessories WellGate 2504 x 1 pcs AC to DC+12V Power adaptor x 1 pcs CD User Manual x 1 pcs Warranty One year

WellGate 2504 IPv6 YES SIP YES H.323 NO NAT for WAN/LAN YES Routes and Dial Plans YES Rich Telephony Features YES Enclosure Metal Black

WellGate-2504 4-Lines FXS SIP IP Gateway

Price Fob Taipei Taiwan : 190 USD

We can ship you via UPS, DHL, TNT, FedEx, Air Cargo etc.
Shipment cost depending on weight and destination.
Delivery commences is in 1-3 days upon receipt of you payment.
Export port : Taipei, Taiwan.

Payment options: Bank transfer, Western Union, or cash.

Price for web online payments by Pay Pal or Credit Cards is 7% high

We can send you shipment by any volume and description on delivery commercial invoice that you need for better meeting shipment and customs requirements and saving costs. Also we can send the shipment as is a free samples or free gift.

Please do not hesitate to contact us. E mail : sales@cordless4u.com